Power: 62.2 kW (blower fan 7.5 kW × 6, spray 0.75 kW × 2 frequency conversion, drive 3 kW × 3 frequency conversion, wet-ejected 1.5 kW, cooling 2.2 kW)
Heating Methods Available
Thermal oil for circulation
Vapour heating
Gas burner
Drying System
Drying areas use top-blowing and bottom-suction method with hot air penetration and convection for high heat efficiency
Drawer-like air duct is easily accessible for cleaning at any time
Two air circulation fans face-to-face located with top-blowing and bottom-suction method, hot air penetration and convection
Vents on both sides of the top with the same fan hp to remove volatile gases
Cooling fan installed on the output end for cooling the web
Construction
Main framework plate is 1.5 mm to 2 mm cold plate
Main frame joints by 100 × 100 square tubes, 10# groove steel and 5# angle steel
Clapboard is used by 1.5 mm cold plate
Heat insulating plate is sealed by heat resistant silicide nitrile rubber, inside filled with heat-insulation fill and surface is made of 1.2 mm cold plates
Thickness of heating isolating plates is 10 cm
Conveyor and Drive
Wire netting apron
Controlled drive for the conveyor belt
Included and Excluded Items
No exit wind up included
No feed unit included at the entry
Request a Quote
✓
Request sent
Thank you, our team will reply to you shortly.
Direct access to our team
Email American Plant & Equipment
Tell us what you want to buy, source, finance, or sell. A machinery specialist will follow up with you.
✓
Thank you. Your request is with the American Plant and Equipment team.
A machinery specialist will follow up with you.
Machinery updates
Subscribe to our email list
Tell us which industries you follow and we will send you the machines that match.
✓
You are on the list.
We will email you when machines that match your interests come in. Unsubscribe from any message.
