Description Overview Inventory number: E-4086 Nordson hot melt fabric back coating and laminating system Year: 1998 Designed to back coat textiles with hot melt adhesives Uses 100% solids with no emissions or drying Increased line speeds (30 meters/minute) without the use of tenter frames Lower coating costs without the need for on-site compounding Minimum changeover requirements for coating widths, weights and adhesive types Gear pump metering systems deliver consistent add-on weights without regard to changing line speeds Application Specifications Maximum coating speed: 30 mpm (note 1) Minimum coating speed: 7 mpm (at maximum coating width) Maximum coating width: 1676 mm (66) (note 1) Minimum coating width: 1219 mm (48) Maximum add-on coating weight (EVA): 60 grams/m (note 2) (oz/yard note 2) Maximum melt rate (EVA): 400 lbs/hr (66 in width x 30 mpm) Maximum add-on coating weight (co-polyester): 40 grams/m (note 2) (1.2 oz/yard note 2) Maximum melt rate (co-polyester): 275 lbs/hr (66 in x 30 meters/min x 40 grams/m note 2) Coating tolerance: +/- 6 grams/m (note 2) (+/- 0.21 oz/yard note 2) Note 1: Achieving maximum conditions stated are subject to melt rate limitations Note 2: Dependent on adhesive type and viscosity System Type and Configuration Slote die system which does not require a dryer More efficient than a scatter system Includes a set of nip rolls for laminations Additional equipment required: let-off and take-up equipment (not included)
