Designed for crushing HR foam buns up to 45 inches (1.143 m) high by 96 inches (2.4384 m) wide
Complete crushing of a maximum bun height may require multiple passes of equal increments down to a minimum machine gap of 8 inches (203 mm)
Frame
Heavy-duty wall structural channel reinforced with steel mechanical tubing weldment
Lower Carriage
Heavy-duty weldment in fixed position containing six powered rollers each 10 inches (0.254 m) in diameter by 100 inches (2.54 m) long
Upper Carriage
Same as lower carriage except pivoted via a hydraulic cylinder
Includes protractor dial to assist setting gap
Roller Drive
20 hp variable speed drive
Hydraulic Unit
Self-contained, 2500 psi capacity, with reservoir
Crushing Force
Approximately 20,000 lbs (6,800 kg) evenly distributed across width
Gap
8 inches (203 mm) minimum to 34 inches (864 mm) maximum via pushbutton control
Charge Height from Floor
34.5 inches (876 mm)
Discharge Height from Floor
24 inches (610 mm)
Roll Speed
Variable, 10 - 25 fpm (3 - 7.6 m/min)
Controls
Nema 12 frame mounted enclosure including all necessary operator controls for variable roll speed, hydraulic power unit, and upper carriage raise and lower
Includes emergency stop button on both sides of the machine
Power Requirement
480 volt, 60 cycle, 3 phase at 30 amps
Condition
Picture available
Request a Quote
✓
Request sent
Thank you, our team will reply to you shortly.
Direct access to our team
Email American Plant & Equipment
Tell us what you want to buy, source, finance, or sell. A machinery specialist will follow up with you.
✓
Thank you. Your request is with the American Plant and Equipment team.
A machinery specialist will follow up with you.
Machinery updates
Subscribe to our email list
Tell us which industries you follow and we will send you the machines that match.
✓
You are on the list.
We will email you when machines that match your interests come in. Unsubscribe from any message.
