Marshall & Williams stainless steel pipe scray, 128" wide with driven pull roll
Manual 4-roll spiral type brusher, 130" mounted on gantry
Erhardt + Leimer pivot guider type FF1353
Sky-stand approximately 12 feet long
Pre-Dryer and Finishing
Marshall & Williams gas fired pre-dryer, 4-burner, single pass
Evac water and lint removal system, 50 hp, 575 volts, 130" slot trap and silencer
Kusters horizontal finishing padders, 21" diameter rubber rolls, double dip immersion pans (with only one immersion roller in place), 15 hp, dc drive motor
Bianco weft straightener, 130" face width, 8 optical heads, year 1994
Operator platform
Tenter Frame
Marshall & Williams clip tenter entry with 122" feed, swing rails, with Erhardt + Leimer rail guiders, proportional rail drivers
Marshall & Williams 4-zone low profile gas fired house with Maxon 415 burners and eight 15 hp circulation fans (two per zone)
10-foot exit section with stripper roll, Mount Hope skew attachment and 3-roll draw set and Bianco straightening station with 4 optical heads
3 - 130" cooling cans (chilled water)
Accumulator and Winder
Menzel 120" wide accumulator with 11 rolls up and 12 rolls down, 3 yards travel for total of approximately 72 yards capacity, chain drive on each corner
Marshall & Williams 2-roll draw set
Menzel a-frame winder, year 1990, converted to electric drive on lay-on roller, hydraulics used only for lifting lay-on roll
Request a Quote
✓
Request sent
Thank you, our team will reply to you shortly.
Direct access to our team
Email American Plant & Equipment
Tell us what you want to buy, source, finance, or sell. A machinery specialist will follow up with you.
✓
Thank you. Your request is with the American Plant and Equipment team.
A machinery specialist will follow up with you.
Machinery updates
Subscribe to our email list
Tell us which industries you follow and we will send you the machines that match.
✓
You are on the list.
We will email you when machines that match your interests come in. Unsubscribe from any message.
