Description Overview Kleinewefers transfer printer / laminator, consisting of multiple components Kannegieser Multi Star CX laminator Kleinewefers Transfer Printer / Laminator Components C&M series 627 overhead hoist, ½ ton Menzel A-frame unwinder with hydraulic connection (not a surface batcher), includes a 90” 6-roll light compensator Let off stand with mini super chucks, 1 ¼” square bar, approximate 84”, 2 rolls to bring material under the operator’s platform into the Kleinewefers Kleinewefers single cylinder transfer / laminator 2-station fabric let off with electric guider 72” entry slot roll, approximately 14” diameter 82” x 3” air bar mounted on the front 75” mesh conveyor belt / blanket running on a 79” carry roll Main cylinder of the Kleinewefers is 84” wide and is thermal hot oil heated 77” rubber press roll that presses the blanket against the cylinder for carrying the fabric 75” surface type batcher (at rear of machine), hydraulic, for the final wind-up Hot Oil Heater Made by First Thermal Systems, Chattanooga, Tenn Design duty is 1.6 mm btu’s per hr Gross input is 2.2 mm btu’s per hr Heating surface is 159 sq. ft Operating max. temp. is 450 Fuel is natural gas Fluid oil is para.nf Minimum flow rate is 130 gal/min Safety valve setting is 150 psi Power Flame burner, model CR2-G-20A, natural gas at 2200 mbh, 115 volts on the controls and 460 on the motor Kannegieser Multi Star CX Laminator 62” conveyor section, 40” entry, 3’ exit Unit is 88” wide, type CX1600C 400 volt, 3 phase, 60 supply, 71 amp Control air pressure is 93 lbs Weight of machine is 3,087 lbs Process control thermal F control Menzel A-frame winder at the exit
