Description Overview DG318 tenter frame - electric heated 72 inch entry width, 90 inch trim at exit - special for knit finishing, drying, and heatsetting 440 volt, 60 hz Roll to roll feed and exit Machine length: 13,500 mm for DG318; overall width: 4,300 mm Drying chamber length: 2,500 mm total Shipped in One 53 foot van Heating System Electric heating with electric heating tube (resistance wire enclosed in stainless steel casing) 450 degrees fahrenheit maximum temperature Approximately 80 kw electric load for the drying oven (DG318) Total load for the whole machine is 96 kw Fan motor is 7.5 kw; smoke exhaust Air needed for DG318 is 250 to 350 cubic meters per minute Air pressure is 1,000 to 1,500 pascals Entry Section Four-finger uncurlers at the entrance Gummers at the entrance Edge guiders at entry of pad and entry of tenter Pad at the entrance - two rolls, inclined rolls Padder: copy LK from Taiwan with extended dips to allow for 1,000 mm dwell, with 7.5 kw motor Padder cylinder diameter is 350 mm, rubber coated with 4 to 8 kg per square centimeter force Two feed tanks, 50 gallons, with stirrers, automatic level control; not including framework to hold the tanks Including the grid floor to hold the tanks; we will furnish diagram to build the framework ladder and rails Exit Section Slitter at the exit Flat folder at the exit Fabric width at exit, after the trimmers, as needed by client Chain and Drive Horizontal pin chain Reduction gear box: Changzhou Guomao Guotai Range of speed from 0.25 to 5 meters per minute Electrical System Siemens brand for electrical compOnents/system - Canadian standard Construction and Materials All guide rolls are stainless steel Effective maximum width at entrance: 72 inches (1,828 mm)
