Three-phase asynchronous motor with reducer (including positioning protection device)
Die Head
Die width: 2200 mm
Die material: Germany 2738 steel
Die structure: T-mold, port 0.03-0.04 mm and with hard chromium electroplating mirror polishing
Width adjustment: Outside the wall type, unilateral: 100 mm
Die clearance adjustment: Adjusted by a push-pull type fine thread screw, adjustment amount: 0.5 mm
Die clearance: 1.8 mm
Temperature control: 11 zones × 3 kW, by the intelligent dual display apparatus by SSR solid state relay automatic temperature control
Heating mode: The aluminum heating coil heating, closed connection
Roll Formation
Frame channel steel welded together by 140 mm
Flower roll: 1
Roller specification: ∮500 × 2200 mm
Cooling system: Using spiral flow system, 75 m/min speed in and out of the water temperature is less than 3 degrees
Drive power: 5.5 kW variable-frequency adjustable-speed motor (attached to the reducer)
Cooling Roller
The mirror surface cooling roll specification: ∮270 × 2200
Cooling system: Using spiral flow system
Grinding Roller
Diameter: 2200 mm
Cooling system: Using spiral flow system
Colloid material: The use of special milk white heat easy mold silicone, inclusive of our 30% 400 mesh emery, designated manufacturers
Adjusting the angle of the roll: Aluminum two 30 × 120 × 2200 mm
Traction Part
Iron roll: 214 × 2200
Rubber roll: 210 × 2200
Motor adopts 1.5 cycloid
Winder
Adopted roller friction winding
Winding roller diameter: 500 × 2200
The surface of roller adopts polishing plating
Motor adopts 1.5 cycle
Electric Control Box
Extruder motor and temperature control box
The main control box
Main machine and the motor is controlled by Euromonitor frequency converter, temperature PID intelligent control device, control electronics uses solid state relay, motor adopts Siemens motor
Parameters
Electrical system: 380 V, 50 Hz
Machine installation capacity: 60 kW/h
Capacity: 5-6 t
The size of the machine: 8 m × 14 m × 2.8 m
Included Spare Parts
5 × die heating tubes
Barrel heating circle
Solid-state relay
Temperature controller
One set of the mold tool
Request a Quote
✓
Request sent
Thank you, our team will reply to you shortly.
Direct access to our team
Email American Plant & Equipment
Tell us what you want to buy, source, finance, or sell. A machinery specialist will follow up with you.
✓
Thank you. Your request is with the American Plant and Equipment team.
A machinery specialist will follow up with you.
Machinery updates
Subscribe to our email list
Tell us which industries you follow and we will send you the machines that match.
✓
You are on the list.
We will email you when machines that match your interests come in. Unsubscribe from any message.
