Small stainless steel J-scray with pull roll: 80 inches high by 47 inches front/back, with sky-in stand and E&L KF-20 guiders on bridge
Kusters finishing padder: 140 inch face rubber/stainless steel rolls, 130.5 inches by 18 inch diameter, liquor trough with lift, 15 hp motor and gearbox
3-roll compensator
Vacuum system with Sutorblit pump and 50 hp motor, separator, silencer and 130 inch stainless steel slot
Aztec predryer: 2-pass, 8-burners, gas fired, NYC combustion blower
10 can stack: Morrison 120 inch face width, 126 psi pressure rating, 7.5 hp DC drive motor
Marshall & Williams clip tenter frame: includes operator platform and controls, 132 inch feed roll, Webtech edge sensors and rail guiding system, 13 foot swing rail entry, 6-zone low profile gas fired house with 6 Maxon 415P Ovenpak burners and 12 15 hp circulation fans, 12 foot exit zone with stripper rolls, auto-chain lubrication system, 30 hp DC main drive motor
Menzel 3-roll compensator: 134 inch face
Pipe-type J-scray with driven pull roll, inspection board with overhead lighting and operator platform
M&W 3-roll compensator
Sky-stand on exit with E&L KF-2020 guiders on bridge: 120 inch face width, with hardened roll and anvil mount for score slitter heads, Steadweb tension controls
Krantz 701M automatic batcher: 154 inch face bed rolls, swing-shear cut-off
Main drive, controls, motors, etc.
Range #2 Specifications
Roll table and cradle: 130 inches wide, small diameter rolls
Stainless steel scray with driven pull roll, KF-2020 guiders on bridge
Operator platform
Radiation Systems predryer: single pass, with RSI Thermonitor
Kusters vertical padder: rubber/stainless rolls, 130.5 inch face
Nash SC-7 vacuum system: with 50 hp motor, trap and silencer, 130 inch slot
Radiation Systems predryer: single pass, with RSI Thermonitor
Marshall & Williams clip tenter frame: 150 inch maximum opening, with operator platform, operator controls, 10 foot swing rail entry with rail guiding, M&W 8-zone low profile gas fired house with 8 Maxon 415P Ovenpak burners and 16 15 hp circulation fans, 10 foot exit rail section with stripper rolls
Mahlo sensor
3-roll tension set
Menzel 3-roll compensator 134CP, 1988
Menzel pipe-type scray with slotted pull roll
Sky-stand with Toyo air guiders on bridge
M&W compensator/accumulator: 140 inch face, 4 rolls up and 3 rolls down, with lighted viewing board
Krantz automatic batcher 701M: 154 inch face on bed rolls, shear-cut doffing, and A-frame lay-on roll
Main drive, controls, motors, etc.
Condition
Both ranges are used industrial equipment
Not specified
Request a Quote
✓
Request sent
Thank you, our team will reply to you shortly.
Direct access to our team
Email American Plant & Equipment
Tell us what you want to buy, source, finance, or sell. A machinery specialist will follow up with you.
✓
Thank you. Your request is with the American Plant and Equipment team.
A machinery specialist will follow up with you.
Machinery updates
Subscribe to our email list
Tell us which industries you follow and we will send you the machines that match.
✓
You are on the list.
We will email you when machines that match your interests come in. Unsubscribe from any message.
