NovaStar, LC181, Laminating and Sheeting (Cross-Cutting) Machine, New, 2 Unwinds, 2 Rewinds, 2,540 mm (100 in) Sheet Length, Servo Belt Feeder (New)

New laminating and sheeting (cross-cutting) machine, built to order. Two webs are unwound, laminated through a driven nip and fed by a servo belt feeder to a stop-and-cut cross-cut knife, producing sheets up to 2,540 mm (100 in) long; the release liners are rewound after lamination. Designed for stiff composite fabric such as carbon fiber prepreg laminates.

A. Main Parameters

1. Sheet length: up to 2,540 mm (100 in), on a 2,700 mm servo belt feeder
2. Overall length: 4,054 mm (3,054 mm belt feeder section plus 1,000 mm unwind and laminating section)
3. Overall height: 1,650 mm
4. Roll diameter: 300 mm on the unwinds and rewinds
5. Cutting: stop-and-cut; the line stops at the set length and the knife cuts
6. Sheet removal: by hand from the belt feeder

B. Configuration

1. 2 unwinders (1# and 2#) on safety chucks with 3-inch air shafts
2. Magnetic powder tension control on the unwinds
3. Web guiding on both webs
4. Laminating nip rollers, motor driven
5. 2 rewinds (1# and 2#) for the release liners, motor driven
6. Pressing mechanism at the feeder entry
7. Cross-cut knife
8. Servo belt feeder, 2,700 mm long
9. 5 motors in total (M1 to M5)

C. Notes

1. General arrangement drawing V-2337-GA-01 available; the design is being finalized with the customer's requirement
2. Working width, electrical data and lead time per the final quotation