The TM 2500 Mobile Gas Turbine Generator

The TM 2500 Mobile Gas Turbine Generator Standard Description Quantity: 2 Units Available Immediately. Offered by American Plant & Equipment, the GE TM2500 Mobile Gas Turbine Generator is a fast, reliable solution for most any power generation requirement. The TM2500 is GE’s proven LM2500® gas turbine mounted on wheels. It is the perfect solution for limited space applications, where large power generation capability is required. Rated at 22.8MW @ 60Hz, this power plant is ready of mobilization on a four-trailer assembly. Requiring only minimal site preparation, it can reach full power in as few as thirty days approximately from arrival and has less than a ten-minute start cycle to reach full power. These units are very flexible and have been transported over land, by sea, and by air to some of the most remote places in the world. Mobile power solutions by A.P.E. include many offerings, but no offering would be complete without the industry staple TM2500 Turbine Generator. A.P.E. is ready when you need power… anywhere in the world! GE TM2500 is a powerful solution for virtually any power generation need. Offering both portability and large capacity, the TM 2500 can be commissioned in days, instead of weeks or months. The perfect solution for many base load operations, the TM2500 provides up to 22.8MW at various voltages and frequencies. From backup power generation to support relief efforts for natural disasters, or for plant shutdowns due to equipment maintenance or failure, A.P.E. can help! The General Electric TM 2500 provides the following Key Benefits: • Output: 22.8 MW @ 60 Hz - 21.8 MW @ 50 Hz (ISO) • Dual Frequency – 50/60 Hz quick conversion • Heat Rate: 9500 Btu/kW-hr @ 60 Hz - 9800 Btu/kW- hr @ 50 Hz (ISO) • Dual fuel capability - liquid or natural gas • Brush Air-cooled 2-pole generator with brushless excitation • PC Control - Multiple units can be started/controlled with a single PC • De-mineralized water injection for low emissions (25 ppm w/ gas; 42 ppm w/ liquid) • Variable voltage capability • Woodward “Micronet®” Control System • Heating & Cooling options inlet air • Electro-hydraulic starting system • Small Footprint (~110' x 70') • 90 dBA @ 3 Fee The TM 2500 Mobile Gas Turbine Generator Design The TM 2500 is packaged on a four-trailer system with top-mounted inlet and exhaust assemblies. The TM 2500 is easily transported by air, ship, rail, or tractor-trailer and can be delivered to remote locations around the world. The design of the GE TM 2500 offers quick-connect fittings to help with installation and allow for rapid assembly and setup time. Assembly is often fully complete in just three days. With over 60,000 operating hours experience in a variety of applications, the TM 2500 can be easily converted from 50 to 60 Hz and offers dual fuel capability. Showcasing the LM 2500 aero-derivative gas turbine with an air-cooled Brush, 2 pole generator and brushless excitation, the TM 2500 remains a staple in the world of mobile power generation. Typical Applications With more than 2,000 LM 2500 and TM 2500 units sold for use in power generation applications worldwide, the GE LM & TM series turbine generators are the most experienced & reliable turbine solutions available. Common uses include: • Base load power generation stations for remote areas • Supplemental power for peak shaving or managing seasonal demands • Supplemental power due to local generation constraints (hydro shortages, plant outages, etc.) • Temporary power for power plants or for large-scale industrial or commercial projects • Maintenance outages, overhauls, or local T & D support • Emergency power support following natural disasters