TT-4911 DILO DI-LOUR 25 MACHINE, WORKING WIDTH 2500mm, YEAR 1987

REFERENCE NUMBER: TT-4911 DILO DI-LOUR 25 MACHINE, WORKING WIDTH 2500mm, YEAR 1987 DILO DI-LOUR 25 MACHINE RECENTLY RECONDITIONED AND UPGRADED WITH A NEW ELECTRICAL CONTROLS SYSTEM WORKING WIDTH 2500mm YEAR BUILT 1987 WE RECONDITIONED AND UPGRADED IN AUGUST 2021 MAXIMUM DAYLIGHT: 12.5” (WITHOUT SAFETY GUARDING ON INLET) NEEDLE BOARDS: 2 NEEDLE BOARDS AND 1 DUMMY BOARD NEEDLE POPULATION: 8000 NEEDLES PER METER MAIN MOTOR: 34.5 KW (460 V); 30 KW (400 V) ESTIMATED NUMBER OF BRUSHES: 1640 BRUSH BRISTLE HEIGHT: 20mm MAXIMUM ECCENTRIC RPM: 980 MAXIMUM BRUSH CONVEYOR SPEED: 5.6 METERS PER MINUTE MAXIMUM DRAW-OFF ROLLER SPEED: 6 METERS PER MINUTE ELECTRICAL CONTROLS: 4 HMI SCREENS 1) MAIN SCREEN: ECCENTRIC SPEED (SPM), BRUSH CONVEYOR SPEED (m/MIN), DRAW-OFF ROLLER SPEED (m/MIN), PENETRATION DEPTH (mm), GAP (mm), STITCH DENSITY: (cmXcm), RUN TIME 2) ADJUSTMENT SCREEN: AUTO PENETRATION DEPTH (mm), AUTO GAP DEPTH (mm), MANUAL PENETRATION DEPTH (mm), MANUAL GAP DEPTH (mm) 3) GREASE SYSTEM: AUTOMATIC GREASE TIME INTERVALS, MANUAL GREASE SYSTEM 4) BRUSH CLEANING MODE: AUTOMATIC CLEANING TIME, MANUAL SETUP OF CLEANING PROCESS AFTERMARKET UPGRADES: 1) ECCENTRIC AIR COOLING SYSTEM: TEMPERATURE AUTO START a. TEMPERATURE SENSORS ON EACH ECCENTRIC 2) CENTRAL LUBRICATION SYSTEM FOR ECCENTRICS AND MAIN BEARINGS: AUTOMATIC (TIME AUTO START) AND MANUAL GREASING a. PRESSURE SENSOR ON GREASE LINES OPTIONAL EQUIPMENT: 1) REWIND STATION (91.5” WIDE ROLLERS) 2) CROSS-CUTTER THE UNIT IS FULLY OPERATIONAL AND COMES WITH A CLEANING ROLLER FOR THE BRUSHES THE BRUSHES ARE IN OKAY TO POOR CONDITION AND WOULD NEED TO BE REPLACED IN THE FUTURE MACHINE ESTIMATED WEIGHT: 7,500 LBS OVERAL MACHINE DIMENSIONS: 157” WIDE x 109” TALL (WITH MAIN MOTOR) x 84” DEEP QUANTITY: 1