TT-6389 AUTOMATIC NON-EMBOSSING REWINDING MACHINE, WIDTH 1800mm -FOR TISSUE PAPER OR TOILET PAPER

REFERENCE NUMBER: TT-6389 AUTOMATIC NON-EMBOSSING REWINDING MACHINE, WIDTH 1800mm -FOR TISSUE PAPER OR TOILET PAPER AUTOMATIC NON-EMBOSSING REWINDING MACHINE EQUIPMENT CONFIGURATION I. TECHNICAL REQUIREMENTS FOR EQUIPMENT: A. RATION: 16 TO 20GSM DOUBLE-PLY PAPER, 18 TO 22GSM SINGLE-PLY PAPER, 13 TO 16GSM THREE-PLY PAPER B. RAW PAPER DIAMETER: ≤ Ȼ 1500mm C. CORE DIAMETER: Ȼ 76mm D. RAW PAPER WIDTH: ≤ 1800mm E. PRODUCTION CAPACITY: MAXIMUM 200M/MIN F. POWER: 1800 MACHINE TYPE 5.5KW II. PERFORATION REWINDING AND SPRAYING DEVICE: A. 4-KNIFE PERFORATION, THE BOTTOM KNIFE WITH PNEUMATIC DEVICE, PERFORATION LIGHT AND FAST, SMALL SOUND, HOLE LINE CLEAR, PERFORATION INTERVAL: 130mm AUTOMATIC SENSOR KNIFE SHAFT PROTECTION SYSTEM. B. REWIND DIAMETER: 70 ~ 135mm C. FULLY AUTOMATIC PAPER TUBE REPLACEMENT DEVICE, WITHIN 2 MINUTES TO ADJUST ANY φ25 TO φ55mm PAPER TUBE. D. LINEAR NOZZLE SPRAYING GLUE, (MUST BE AUTOMATIC) AT THE SAME TIME THE PAPER CUT OFF. E. AUTOMATIC TRIMMING, GLUING AND SEALING IN ONE GO, LEAVING A 10-18mm PAPER TAIL FOR EASY ACTIVATION. III. UNWINDING SECTION: A. PRODUCE 1-3 LAYERS OF PAPER CAN ADJUST THE POSITION OF ORIGINAL PAPER SEPARATELY. B. AUTOMATIC TENSION ADJUSTMENT CAN ADJUST THE ORIGINAL PAPER FORCE SEPARATELY. C. THREE ORIGINAL PAPER FRAME: EACH REWINDING FRAME TWO SETS OF BELT CONVEYOR D. UNWINDING BELT FRAME FOR THE BUFFER CYLINDER PRESSURISATION, THE WHOLE MACHINE GAS PIPE OF NOT LESS THAN Ȼ 10mm, THE MAIN GAS PIPE OF NOT LESS THAN Ȼ 12mm. E. ALL PNEUMATIC ORIGINAL DEVICE, PNEUMATIC PRESSURE ADJUSTABLE. F. THE ORIGINAL PAPER FRAME MUST ENSURE THAT THE DIAMETER OF 0 1500mm SUITABLE FOR THE USE OF THE ORIGINAL PAPER. IV. THE WHOLE MACHINE TRANSMISSION SYSTEM DEVICE: A. THE TRANSMISSION SYSTEM DEVICE ALL INCLUDES CHAIN BELT DRIVE B. INCLUDING TENSION ADJUSTING TENSIONING BELT, PAPER VICE TENSION ADJUSTING C. THE EMBOSSING ROLLER AND KNIFE ROLLER INCLUDE SKF BEARINGS IMPORTED FROM JAPAN. D. KNIFE ROLLER AND EMBOSSING ROLLER SCREWS ARE IMPORTED ACCORDING TO THEIR REQUIREMENTS. V. ELECTRICAL CONTROL: A. THE OPERATION PANEL INCLUDES TOUCH-TYPE MULTI-PICTURE HUMAN-MACHINE INTERFACE OPERATING SYSTEM B. FAULT INDICATOR (OPERATION, WARNING, FAULT) C. INCLUDING INVISION FREQUENCY CONVERSION MOTOR CONTROL D. THE WHOLE MACHINE IS CONTROLLED BY PLC COMPUTER PROGRAMMING TECHNOLOGY, THE OPERATION BUTTON INCLUDES 24V ANSHENG VOLTAGE, AND PART OF THE CONTROL COMPONENTS INCLUDES DELTA OR INVENTEC ELECTRICAL APPLIANCES. QUANTITY: 1