T-9717 COLD PIN PERFORATING UNITS, WORKING WIDTH 1800mm, REFURBISHED

REFERENCE NUMBER: T-9717 COLD PIN PERFORATING UNITS, WORKING WIDTH 1800mm, REFURBISHED COLD PIN PERFORATING UNITS REFURBISHED WORKING WIDTH 1800mm YEAR: UNKNOWN, ESTIMATED TO BE LATE 1990’s WORKS WITH PLASTIC FILM, FOIL OR PAPER AND SOME NONWOVENS COLD PIN PERFORATING UNIT CAN BE USED FOR PERFORATING OR EMBOSSING EASY TEAR LINES FOR BAGS PRODUCT EMBOSSING FOR GRIP OR IDENTIFICATION WEB DRIVEN UNIT DIMENSIONS: 23” (585mm) WIDE X 36” (915mm) TALL X 105” (2667mm) LONG NO PINNED TOOLING IS INCLUDED WITH THE UNIT HOWEVER, A WIDE RANGE OF PINNED TOOLING CAN BE USED WITH THIS UNIT TO CREATE AN ARRAY OF HOLE SIZES AND PATTERNS. 1 BASE MACHINE FRAME ALUMINIUM/STEEL/STAINLESS, 1800mm WORKING WIDTH 1 PNEUMATICS FOR ACTUATION AND PRESSURE ROLL CONTROL 1 ROLLER FOR PINNED SLEEVES, 110mm DIAMETER WITH BEARINGS 1 PRESSURE BRUSH ROLLER WITH BEARINGS TO SUIT 2 IDLER ROLLERS WITH INTERNAL BEARINGS TO GUIDE WEB PATH. 1 SAFETY GUARD, SHEET STEEL, AND FRAME POWDER COATED BOTH THE ANVIL ROLLER AND PINNED ROLLER ARE WEB DRIVEN. THERE ARE NO ELECTRIC MOTORS OR DRIVES, AND THERE IS NO LINK BETWEEN THE ROLLERS. TECHNICAL SPECIFICATIONS: MACHINE APPROXIMATE DIMENSIONS: WIDTH: 585mm (23”) LENGTH: 1800mm (WORKING WIDTH) + 867mm TOTAL OF 2667mm (105”) HEIGHT: 915mm (36”) WEIGHT: 350KG COMPONENT DETAILS: SHAFT: STEEL, 110mm OD, POLISHED FOR EASE OF PINNED SLEEVE MOVEMENT MOUNTING: PERFORATOR SIMPLY BOLTS ONTO YOUR EXISTING MACHINERY. PENETRATION DEPTH: THE PERFORATOR COMES STANDARD WITH MANUAL PENETRATION CONTROLS. SYSTEM REQUIREMENTS: AIR PRESSURE: 6.25 TO 8 BAR / 90 TO 100 PSI POWER: NOT REQUIRED, MACHINE IS WEB DRIVEN NOTE: IT IS STRONGLY SUGGESTED THAT A FEW SPARE PINNED SLEEVES ARE PURCHASED AT THE TIME OF ORDER, AS THE LEAD TIME FOR REPLACEMENT SLEEVES IS TYPICALLY 8 WEEKS. NO PINNED TOOLING IS INCLUDED WITH THIS QUOTE. WHEN ORDERING PINNED TOOLING: THE SMALLEST HOLE WOULD BE AROUND 100µ Ø, LARGEST AROUND 1000µ Ø DEPENDING ON WHAT SIZE PIN IS USED. HOLE POPULATIONS COULD BE ANYTHING UP TO 400 PINS PER SQUARE INCH, DEPENDING ON THE MATERIAL THAT IS BEING PERFORATED AND THE HOLE SIZE REQUIRED. UNITS WERE PREVIOUSLY HOT PERFORATING UNITS BUT THE HEATERS AND ELECTRONICS HAVE BEEN REMOVED SO THEY ARE BEING SOLD AS COLD PIN PERFORATING UNITS MACHINES WILL BE READY TO INSTALL UPON PURCHASE QUANTITY: 2